Under Network Setup, change the Router IP to a different subnet than that of your primary router. Step 11: Head to the Security section, disable the SPI Firewall, and uncheck everything housed under Block WAN *Requests. Step 10: Hit* Save*, but again hold off on Apply Settings. It’s best to make these identical to the settings in the Physical Interface section. Step 9: Under the Virtual Interfaces section, you’ll establish the settings you’ll use to connect to this router. For example, if your primary router uses WPA2 Personal with TKIP encryption, set things the same here, and enter your key as you would if you were connecting from a PC or phone. Under the Physical Interface section, make sure the settings exactly match those of your primary router. Step 8: Now let’s head to the Wireless Security section. You should wait until you’re completely finished. Step 7: Hit* Save*, but do not hit Apply Settings just yet. Just don’t use the same name as your primary network. We used Potcasting-Repeat, but you can use whatever name you like. Step 6: Give the new virtual interface a unique SSID. Step 5: Under Virtual Interfaces, click Add. We chose Potcasting, because that’s the name of the router we’re hoping to repeat.

Step 4: Set the SSID to match your router. This might require some research on your part, though Mixed is fairly universal. Step 3: Set Wireless Network Mode to match your router. Step 1: First, head to the Wireless section and click the Basic Settings tab. The default SSID will be “dd-wrt,” and you’ll need to set an admin username and password. If the router is currently plugged into any network, unplug it - we don’t need any Ethernet cables for a repeater. Otherwise, you can proceed full steam ahead with DD-WRT. Look for these options before downloading DD-WRT just to make sure they aren’t available.

Fortunately, many of our steps below can be used with native settings that allow it, even if things look different: Linksys, for example, has a different interface, and the method that Netgear’s Nighthawks use is also a bit different, while the Asus mode differs as well. Keep in mind that some router models (especially older routers) do allow you to set up the router as a repeater natively, which means you don’t need to use DD-WRT. When this is done, you’re ready to do some configuring. That’s right: You’re holding the button for 30 seconds with the router on, then 30 seconds with the router off, then 30 seconds with the router on again. Keep the Reset button pressed down for 30 seconds. Step 3: Keep holding the* Reset* button, and plug the router in. The best tablets in 2023: top 9 picks you should buy The most common Zoom problems and how to fix them How to screen record on an iPhone or iPad

Cisco linksys e4200 setup software